Get in touch

In Auckland, and need a quote? Get in touch today.

Contact Us →

Gasfitting Services Auckland

Need gas heating installed or gas appliances fitted in Auckland? Our certified gas fitters handle all your heating and gas installation needs safely.

Get in touch

In Auckland, and need a quote? Get in touch today.

Contact Us →

Leaking or Dripping Tap? Why It Happens and When to Call a Plumber

TL;DR

A dripping tap is usually caused by a worn part inside the tap, such as a washer, cartridge or seal. Many drips can be fixed without replacing the whole tap. Call a plumber if the tap leaks from the base or handle, if water is getting under the sink, or if the tap will not turn off.

Key Takeaways

  • Most dripping taps have a worn washer, cartridge or seal inside.
  • A small drip still wastes water and can stain the basin or sink.
  • Turn the water off at the valve under the sink if you can, and do not force the tap.
  • Leaks from the base, handle or pipes under the sink need a plumber.
  • An old or worn tap is sometimes better replaced than repaired.

Leaking tap repair is one of the most common plumbing jobs in Auckland homes, and a dripping tap is easy to ignore. It rarely fixes itself. The drip gets faster over time, the basin starts to stain, and you can lose sleep to the plink in the night. Most of the time the cause is small and the repair is simple.

In this post, you’ll learn why taps leak, what you can safely check yourself and when it is time to call a plumber.

Why taps start to leak

Every tap has a part inside that stops the water when you turn it off. In an older two-handle tap that is usually a rubber washer. In a single-lever mixer or a modern tap it is usually a cartridge or ceramic disc. Over years of use these parts wear down, and the tap can no longer seal properly. Rubber seals (O-rings) around the spout or handle wear in the same way, which is why some taps leak around the base instead of from the spout.

Where the water appears tells you a lot. A drip from the spout when the tap is off points to a worn washer or cartridge. Water around the handle or the base of the tap points to a worn seal. Water under the sink points to a problem with the tap connections or the pipes below, and that needs a closer look.

What you can check yourself

Start by finding the small isolation valves under the sink. Turning these off stops the water to that tap, so you can stop a leak while you wait for help. Turn them gently. If a valve is stiff or will not close fully, leave it alone and call a plumber, because forcing an old valve can make things worse.

Next, look under the sink with a torch. Dry the pipes and connections with a cloth, then watch for fresh moisture. If you find a wet patch, take a photo. It helps your plumber understand the problem before they arrive.

It is fine to wipe the tap, clear any build-up around the spout and check that the handle is not loose. We do not recommend pulling a tap apart unless you are comfortable doing it. A tap that is put back together wrongly can leak worse than before.

When to call a plumber

Call a plumber if the tap still drips after you have turned it off firmly, if the leak is at the base or the handle, or if there is water or damp under the sink. Call too if the tap is very stiff, if the water is hot and cold at the same time, or if you have already tried a repair and the leak has come back.

A plumber will also tell you honestly if the tap is worth repairing. A tap that is old, corroded or hard to get parts for can be better replaced. A new mixer is often a simple swap, and you can choose a style that suits your kitchen, bathroom or laundry. You can read more about what we do on our leaking tap repair page and our plumbing services page.

What a drip really costs you

A tap that drips all day wastes water, and if it is the hot tap you are also wasting the energy used to heat that water. Each drip is small, but the cost builds over weeks and months. A drip can also leave stains on a basin, bath or laundry tub, and a slow leak under a sink can soak into the cabinet and floor before you notice it.

It is also worth knowing that tightening a dripping tap harder rarely helps. Overtightening can damage the seat or the washer inside and make the leak worse, so turn the tap off firmly but not with force.

What to tell your plumber

When you call, tell us which tap it is, whether the drip is from the hot side, the cold side or both, and where the water appears. Mention how old the tap is if you know, and send a photo if you can. The more we know, the more likely we are to arrive with the right part.

Get your tap fixed

Grace Plumbing is based on Ireland Road in Mount Wellington and looks after homes in Ellerslie, Remuera and Mission Bay as well. Call us on 09 525 5733 or get in touch through the website, and tell us what the tap is doing. We will work out whether it needs a repair or a replacement. Grace Plumbing is open Monday to Friday, 7:30am to 4:30pm. Residential work is backed by the $20,000 Master Plumbers Guarantee. See the areas we serve for more.

Related reading

Grace Plumbing - Plumbing Solutions and Services

Quick links

Based on 500+ Reviews

☆☆☆☆☆ (4.9/5)

★★★★★
The team at Grace were flexible and were able to slot in my job at ...
Read More
Kevin Sherlock
★★★★★
The team at Grace were flexible and were able to slot in my job at short notice. Great communication throughout
★★★★★
Awesome experience with the team at Grace Plumbing from start to finish. Great communication
Tommy
★★★★★
Awesome experience with the team at Grace Plumbing from start to finish. Great communication
★★★★★
Ryan carried out the work and was friendly, efficient, and highly professional.
Taki Smart
★★★★★
Ryan carried out the work and was friendly, efficient, and highly professional.
★★★★★
The customer services person on the phone was fantastic - very helpful and understanding.
Mark Warden
★★★★★
The customer services person on the phone was fantastic - very helpful and understanding.
Secret Link